Basic Guide for A Combination of Disc and Belt Sander
The disc and belt sander combo are ideal for woodworking. The purpose of using this combination is to make all sorts of materials smooth with efficiency like plastic and wood and helps to do this quickly. The disc sander is mainly used for shaping rough and creating outside curves. On the other hand, the typical use of a belt sander is sanding the wood or material that is utilized for the same.
This article covers the basic parts which a disc and belt sander combo comprise of along with methods how to sand wood properly to create the optimal piece which is desired of merchandise in order and some maintenance tips.
Basic Parts Identification of Belt and Disc Sander
1. A Sanding belt
2. A disc table
3. A belt table
4. A miter head slot
5. Table adjusting materials
6. Sanding disc screw
7. Belt track adjusting
8. Off/On switch screw
9. A bevel scale
Belt and Disc Sander Safety
To stay safe, you must wear safety glasses at the time of operating the disc and belt sander. You should also wear a dust mask respirator when using the combination of disc and belt sander for elongated periods of time. Keeping the sanding disc glued well to the disc plate since the sanding disc rotates in an anti-clockwise direction by helping the sanding action to hold the stock down on the table position that allows the material to the left edge being sanded from the center of the disc. It is because, stock positioning, in this manner from the center of the disc to the right edge will pick the sanding action by stocking up and creating an unsafe condition.
Reaching across the sanding disc could be handy while turning the sander on or off. If your arm or hand may touch the edge of the rotating disc, it can cause an entanglement which might lead a serious cut. To turn the machine off, you should always move to the front of the sander. Another important thing is, you should never wear baggy or loose clothes at the time of operating the disc and belt sander. Never forget to disconnect the electrical power connected to the sander when changing the disc or belt or even making any major adjustments. Try to position yourself in order to through the sanding dust toward the breathing zone. Never apply much pressure on the sanding disc or belt (you may rather hold the stock steadily as it is being sanded) since it makes the sander slows down. Be cautious, when sanding, never allow your fingers or hands to touch the belt or disc.
The Operating Procedures for a Belt and Disc Sander Combo
At first, you need to adjust the disc table which is sanded so that you can achieve the desired angle on the stock. The table of most of the sanders can be adjusted up to 45 degrees. Sanding a precise angle on the material, you have to use the miter head by holding and moving the stock. A firm pressure is needed to apply on sanded stock but that should not be in an excessive amount on the belt or disc sander. On most sanders, you can adjust the belt sanding attachment from a horizontal to vertical position. To get the best sanding job performed, adjustment settings of the belt tracking mechanism fits in a way so that the sanding belt rotates without touching the machine housing. Bear in mind that, you will not become over-balanced at the time of operating the belt and best disc sander combo. Keeping the floor area around the sander clear away from sawdust is necessary to lessen the chances of slipping on a slick floor. As safety comes first, you should turn the machine always off when you are leaving your work area. Before attaching a new sanding disc to the plate, you should change the old sanding disc by pulling off the disc plate and then, apply an adhesive new coating to the plate. When you are about to change the sanding belt, you need to left off the belt tension. The new belt is installed after the old belt is slipped off the pulleys. Make sure that the arrows point in the same direction on the new belt as the arrows on the old belt indicates.
At the same time, it helps to remove a little amount of wastage from sundry products. You might be a keen DIYer or a home hobbyist or you might be working in any commercial furniture making operation, we have got you covered with a basic user maintenance guide for the combination of disc and belt sander. This appreciates much to support our work when users skim through our independently chosen editorial picks.
